Heats of formation of [2.2]paracyclophane-1-ene and [2.2]paracyclophane-1,9-diene - an experimental study

The enthalpies of formation [Delta(g)] of tricyclo[8.2.2.2(4,7)]hexadeca-1(13),2,4(16),5,7(15),10(14),11-heptaene (2, 1,2-dehydro[2.2]paracyclophane or [2.2]paracyclophane-1-ene) and tricyclo[8.2.2.2(4,7)]hexadeca-1(13),2,4(16),5,7(15),8,10(14),11-octaene (3, 1,2,9,10-dehydro[2.2]paracyclophane or [2.2]paracyclophane-1,9-diene) have been determined by measuring their heats of combustion in a microcalorimeter and their heats of sublimation by the transpiration method. Values of the strain energies (SE) [SE(2) = 34.7 kcal mol(-)(1), SE(3) = 42.0 kcal mol(-)(1)] have been derived from the gas-phase heats of formation and are compared with those from MM3 and PM3 calculations and with the corresponding value SE(1) = 30.1 kcal mol(-)(1) for the parent tricyclo[8.2.2.2(4,7)]hexadeca-1(13),4(16),5,7(15),10(14),11-hexaene (1, [2.2]paracyclophane). The higher strain energies of 2 and 3 (by 4.6 and 11.9 kcal mol(-)(1)) are in accord with the well-known increased reactivities of their aromatic rings as a consequence of their increased bending. As revealed by an X-ray crystal structure analysis, the bending in the monoene 2 corresponds to that of 1 and 3 at one of two bridging corners.     

Analysis of carbohydrates by anion exchange chromatography and mass spectrometry

A versatile liquid chromatographic platform has been developed for analysing underivatized carbohydrates using high performance anion exchange chromatography (HPAEC) followed by an inert PEEK splitter that splits the effluent to the integrated pulsed amperometric detector (IPAD) and to an on-line single quadrupole mass spectrometer (MS). Common eluents for HPAEC such as sodium hydroxide and sodium acetate are beneficial for the amperometric detection but not compatible with electrospray ionisation (ESI). Therefore a membrane-desalting device was installed after the splitter and prior to the ESI interface converting sodium hydroxide into water and sodium acetate into acetic acid. To enhance the sensitivity for the MS detection, 0.5 mmol/l lithium chloride was added after the membrane desalter to form lithium adducts of the carbohydrates. To compare sensitivity of IPAD and MS detection glucose, fructose, and sucrose were used as analytes. A calibration with external standards from 2.5 to 1000 pmole was performed showing a linear range over three orders of magnitude. Minimum detection limits (MDL) with IPAD were determined at 5 pmole levels for glucose to be 0.12 pmole, fructose 0.22 pmole and sucrose 0.11 pmole. With MS detection in the selected ion mode (SIM) the lithium adducts of the carbohydrates were detected obtaining MDL's for glucose of 1.49 pmole, fructose 1.19 pmole, and sucrose 0.36 pmole showing that under these conditions IPAD is 3-10 times more sensitive for those carbohydrates. The applicability of the method was demonstrated analysing carbohydrates in real world samples such as chicory inulin where polyfructans up to a molecular mass of 7000 g/mol were detected as quadrupoly charged lithium adducts. Furthermore mono-, di-, tri-, and oligosaccharides were detected in chicory coffee, honey and beer samples.     

Development, validation and transfer of a hydrophilic interaction liquid chromatography/tandem mass spectrometric method for the analysis of the tobacco-specific nitrosamine metabolite NNAL in human plasma at low picogram per milliliter concentrations

A highly sensitive bioanalytical method based on a simple liquid/liquid extraction and hydrophilic interaction liquid chromatography with tandem mass spectrometry (HILIC/MS/MS) analysis has been developed, validated and transferred for the determination of 4-(methylnitrosamino)-1-(3-pyridyl)-1-butanol (NNAL), a tobacco-specific nitrosamine metabolite. Deuterated NNAL (NNAL-d(4)) was synthesized and used as the internal standard. This method can be used for the analysis of free and total NNAL (free NNAL plus NNAL-gluc) in K(3)-EDTA human plasma. Free NNAL and NNAL-d(4) are extracted from human plasma by liquid/liquid extraction. To analyze for total NNAL and the internal standard, a separate aliquot of the K(3)-EDTA human plasma is treated with beta-glucuronidase to deconjugate the NNAL-gluc; the total NNAL and internal standard are then extracted using liquid/liquid extraction. After drying down under nitrogen, the residue is reconstituted with acetonitrile and analyzed using positive ion electrospray and HILIC/MS/MS at a flow rate of 1.0 mL/min. The chromatographic run time is 1.0 min per injection, with retention time for both NNAL and NNAL-d(4) of 0.75 min with a capacity factor (k') of 2. The standard curve range for this assay is from 5.00-1000 pg/mL for both free and total NNAL, using a total plasma sample volume of 1.0 mL. The interday precision and accuracy of the quality control (QC) samples demonstrated <7.6% relative standard deviation (RSD) and <3.3% relative error (RE) for free NNAL. For total NNAL, the interday precision and accuracy of the QC samples demonstrated <11.7% RSD and <2.8% RE. Optimization of enzyme hydrolysis of NNAL-gluc is discussed in detail. The overall recoveries for free and total NNAL and IS were 68.2 and 71.5% (free) and 70.7 and 65.5% (total). No adverse matrix effects were noticed for this assay.     

Temperature-dependent behavior of a symmetric long-chain bolaamphiphile with phosphocholine headgroups in water: from hydrogel to nanoparticles

The temperature-dependent self-assembly of the single-chain bolaamphiphile dotriacontan-1,1'-diyl-bis[2-(trimethylammonio)ethyl phosphate] (PC-C32-PC) was investigated by transmission electron microscopy (TEM), differential scanning calorimetry (DSC), Fourier transform infrared spectroscopy (FT-IR), X-ray scattering, rheological measurements, and dynamic light scattering (DLS). At room temperature this compound, in which two phosphocholine headgroups are connected by a C(32) alkyl chain, proved to be capable of gelling water very efficiently by forming a dense network of nanofibers (Kohler et al. Angew. Chem., Int. Ed. 2004, 43, 245). A specific feature of this self-assembly process is that it is not driven by hydrogen bonds but solely by hydrophobic interactions of the long alkyl chains. The nanofibers have a thickness of roughly the molecular length and show a helical superstructure. A model for the molecular structure of the fibrils which considers the extreme constitution of the bolaamphiphile is proposed. Upon heating the suspensions three different phase transitions can be detected. Above 49 degrees C, the temperature of the main transition where the alkyl chains become "fluid", a clear low-viscosity solution is obtained due to a breakdown of the fibrils into smaller aggregates. Through mechanical stress the gel structure can be destroyed as well, indicating a low stability of these fibers. The gel formation is reversible, but as a drastic rearrangement of the molecules takes place, metastable states occur.     

Magnetic Anisotropy of Dichlorobis(η5‐cyclopentadienyl) Complexes of Vanadium,Niobium, and Tantalum

Abstract. The magnetic behavior of the mononuclear nd¹ systems MCp₂Cl₂ (M = V⁴⁺[3d¹], Nb⁴⁺[4d¹], Ta⁴⁺[5d¹], space group P2₁/c, pseudosymmetry of the molecules C_2v) deviates from pure single ion spin magnetism on account of ligand field effect (H_lf), spin‐orbit coupling (H_so), and intermolecular spin‐spin exchange interactions (H_ex). For both VCp₂Cl₂ and NbCp₂Cl₂ excellent adaptations to the measured susceptibility data were obtained (2 K ≤ T ≤ 300 K) on the basis of spectroscopic data (lf, so) and cooperative metal–metal interactions (ex) of antiferromagnetic nature [molecular field model (mf)]. For TaCp₂Cl₂ experimental term structure data are not available. Therefore, Jørgensen's spectroscopical series (g‐factor of the central ion) was applied to extrapolate the data set for TaCp₂Cl₂. H_lf, H_so, and H_ex (antiferromagnetic) increase in the order 3d¹ → 4d¹ → 5d¹ leading, with rising atomic number of the metals, to a distinct enhancement of the magnetic anisotropy. At 4 K the μ_eff components μ_eff,y (oriented perpendicular to the cg–M–cg plane; “cg” = center of gravity of the Cp ring), μ_eff,z (oriented along the twofold pseudoaxis), and μ_eff,x are 1.73, 1.69, 1.68 (V), 1.73, 1.62, 1.59 (Nb), and 1.71, 1.59, 1.49 (Ta). While μ_eff,y is independent of T, both μ_eff,z and μ_eff,x decrease with decreasing T.     

Small changes—Huge influences: NMR chemical shifts of Ni(II) complexes with polar substrates

Neutral Ni(II) complexes have been shown to be highly valuable as robust and versatile catalysts in olefin polymerization. But they show reduced reactivity when the polar monomers methyl acrylate and vinyl acetate are incorporated. To get further insight into this behavior, NMR chemical shift calculations were performed on the system [(N,O) Ni (H) (PMe3)] 1 (N,O = ‐N,O‐{2,6‐(3,5‐(F3C)2C6H3)2C6H3) NC(H)‐3,5‐I2‐2‐O‐C6H2}). The chemical shifts show reasonable agreement with experiment but are also extremely influenced by geometrical features of the complex as well as the inserted substrate. The first prominent feature, the low‐field shift of the C_carbonyl in the incorporated monomer, can only be reproduced when it is in close proximity to the Ni and in this way hinders the attack of a new monomer. Second, the almost 100 ppm difference in the chemical shift of the carbon of the two substrates directly bound to Ni can be reasoned by the different directionality of polarization as disclosed by natural bond orbital (NBO) analysis. © 2013 Wiley Periodicals, Inc.     

The Roles of Composition and Mesostructure of Cobalt-Based Spinel Catalysts in Oxygen Evolution Reactions

By using the crystalline precursor decomposition approach and direct co-precipitation the composition and mesostructure of cobalt-based spinels can be controlled. A systematic substitution of cobalt with redox-active iron and redox-inactive magnesium and aluminum in a cobalt spinel with anisotropic particle morphology with a preferred 111 surface termination is presented, resulting in a substitution series including Co₃O₄, MgCo₂O₄, Co₂FeO₄, Co₂AlO₄ and CoFe₂O₄. The role of redox pairs in the spinels is investigated in chemical water oxidation by using ceric ammonium nitrate (CAN test), electrochemical oxygen evolution reaction (OER) and H₂O₂ decomposition. Studying the effect of dominant surface termination, isotropic Co₃O₄ and CoFe₂O₄ catalysts with more or less spherical particles are compared to their anisotropic analogues. For CAN-test and OER, Co³⁺ plays the major role for high activity. In H₂O₂ decomposition, Co²⁺ reveals itself to be of major importance. Redox active cations in the structure enhance the catalytic activity in all reactions. A benefit of a predominant 111 surface termination depends on the cobalt oxidation state in the as-prepared catalysts and the investigated reaction.